Canon MG2100 Series On-Screen Manual page 533

An Error Code Is Displayed on the LED
(LED display)
E, 3, 0
(LED display)
E, 3, 1
(LED display)
E, 4, 0
(LED display)
E, 5, 0
(LED display)
This manual downloaded from http://www.manualowl.com
The size of the original
cannot be correctly
detected or the document
is too small when the Fit-to-
Page copying is selected.
The machine is not
connected with the
computer.
The protective material for
the FINE cartridge or the
tape remains attached.
Scanning the print head
alignment sheet has failed.
Make sure that the original is
correctly loaded on the platen
glass.
Check the position and direction
of the original loaded on the
platen glass.
Connect the machine and the
computer with a USB cable.
Check the inside of the machine. If
the protective material or the tape
remains attached, remove it.
When the Protective Material or the
Tape Remains Attached
Press the Stop/Reset button to
dismiss the error, then take the
actions described below.
Make sure that the print head
alignment sheet is set in the
correct position and orientation
on the platen glass.
Make sure the platen glass and
the print head alignment sheet
are not dirty.
Make sure the type and size of
loaded paper is suitable for
Automatic Print Head Alignment.
For Automatic Print Head
Alignment, always load one sheet
of A4 or letter-sized plain paper.
Make sure if print head nozzles
Page 533 of 731 pages