Built-In Wlan / Bluetooth Adapter; Status Leds - R&S TSMA6 Getting Started

®
R&S TSMA6
● GPS / BeiDou
The R&S TSMA6 can perform dead reckoning in tunnels to provide position infor-
mation even if no satellites are available. The dead reckoning is performed by the
device with its built-in electronic gyroscopes.
For enabling untethered dead reckoning, see
dead reckoning",
Depending on the intended use, the respective valid regulations regarding
lightning protection of the antennas and regarding vehicle installation must
be observed during installation.
4.4

Built-In WLAN / Bluetooth adapter

The R&S TSMA6 has built-in WLAN/Bluetooth module (Intel
The R&S TSMA6 WLAN / Bluetooth adapter allows the following modes.
● Client connection to a distant WLAN network
● Serving as a WLAN access point
Per default, the R&S TSMA6 WLAN access point is switched on. The login cre-
dentials are found on the bottom label of the device. The WLAN / Bluetooth can
be switched off (flight mode) via rear panel switch.
Configure the WLAN and Bluetooth settings via web-GUI.
4.5

Status LEDs

The four LEDs on the rear panel display the following states.
● [Scanner State / Scanner Pwr]
Indicates the state of the scanner component
● [Mode]
Indicates the device status
● [Meas]
Indicates the state of the SW application
Getting Started 4900.8040.02 ─ 10
on page 29.
Chapter 3.13, "Calibrating GPS for
®
Wireless AC 8265).
Instrument tour
Status LEDs
35