R&S TSMA6 Getting Started page 32

®
R&S TSMA6
6 = POWER ON/OFF
7 = Restore button
8 = DC IN Connector
9 = USB-C (1x)
10 = USB 3.0 (4x)
11 = USB 2.0 (2x)
12 = LAN Port - Remote Control
13 = HDMI Connector
14 = RF In Connector
15 = Docking Connector
WLAN/Bluetooth ON/OFF
Switches WLAN and Bluetooth on and off.
SCAN port (RJ45 connector)
The SCAN port provides a high-speed 1 Gbit Ethernet interface with an RJ 45
connector. It is used to connect the R&S TSMA6 to a separate R&S TSME6 as a
second scanner. It can be used for MIMO scenarios and for increasing bandwidth
and measurement rate.
AUX Connector
The AUX connector has two functions.
● Input/output: Synchronization with up to 4 connected R&S TSME6 resp. R&S
TSMExxDC (requires sync cable R&S TSME6-ZC2, R&S no. 4900.1800.02 or
R&S TSME6-ZC4, R&S no. 4900.1817.02)
● Input: Synchronization of R&S TSMA6 with an external 10 MHz reference
(requires dedicated sync cable)
GPS Ant. (SMA)
Active GPS antenna port (output voltage 3V, max 25 mA).
Status LEDs
The four status LEDs, [Scanner State], [Scanner Pwr], [Mode], and [Meas] indica-
ted different states of the R&S TSMA6. For a detailed description, see
ter 4.5, "Status LEDs",
Power ON/OFF
Turns the device on and off.
Getting Started 4900.8040.02 ─ 10
on page 35.
Instrument tour
Rear panel view
Chap-
32