Switching On Or Off R&S Tsma6 - R&S TSMA6 Getting Started

®
R&S TSMA6
Figure 3-4: Connected R&S TSMA6/6B and R&S TSMA6-BP
1 = Attach R&S TSMA6 to R&S TSMA6-BP
2 = Move R&S TSMA6/6B to the rear side
3 = Power connection established (docking connector is snapped in)
3.8 Switching on or off R&S TSMA6
To switch on the device
The device is off but connected to power.
► Press the power on/off button.
The Pwr LED starts green blinking. After booting, the color changes to green
resp. blue continuous depending on the state of the WLAN access point (see
Chapter 4.5, "Status
To shut down the device
► Press the power on/off button.
The Pwr LED starts blinking green. The operating system shuts down and the
Pwr LED is switched off.
Getting Started 4900.8040.02 ─ 10
LEDs", on page 35).
Preparing for use
Switching on or off R&S TSMA6
23