Mitsubishi Electric MELDAS MDS-R Series Specifications And Instruction Manual page 258

(6) Back clamp nut tightening, shell tightening
[1] Temporarily tighten the back shell coupling on the straight back shell.
[2] Set the back shell wrench on the back shell coupling.
[3] With the wrench, tighten the back shell coupling on the straight back shell.
(Note) Accurately fit the wrench on the back shell coupling.
Back shell
Tightening guide
 Recommended jigs and tools：Back shell wrench (357J-51333T)
Downloaded from ManualsNet.com
Appendix 1. Cable and Connector Specifications
* To prevent loosening, the adhesive should be applied to the straight back shell.
Recommended tightening: 5Nm
To remove, take the reverse steps.
* Recommendation Adhesive (2 threads around the circumference)
Temporary tightening
Back shell coupling
Set
Back shell
wrench
Back shell
wrench
Bit (357J-51344T)
Torque wrench (CL6N x 8D,Tonichi Mfg.)
* Recommended tightening guide: (357J-50494T)
* Recommended adhesive: screw lock 1401B (Threee bond Co,Ltd)
search engine
Tightening guide
19
* Referential dimensions for
back shell tightening guide
Thickness:
Tighten
* Recommendation:
Tightening guide
(357J-50494T)
A1 - 17
17 (Back shell width)
10