Mitsubishi Electric MELDAS MDS-R Series Specifications And Instruction Manual page 168

(4) Setting of regenerative resistor type
Set the following parameter according to the connected regenerative resistor unit.
No. Abbrev.
SV036
Parameters with an asterisk * in the abbreviation, such as PC1*, are validated with the NC power turned ON again.
If the emergency stop state is displayed on the drive unit's LED, the system has started up normally.
CAUTION
Downloaded from ManualsNet.com
Parameter name
Regenerative
PTYP*
resistor type
F1
F + axis No. Emergency
Normal LED display at NC power ON (1st axis)
Always input emergency stop when starting up the servo system.
search engine
8. Setup
F E D C B A
1 rtyp
bit
8 Set the regenerative resistor type.
9 Setting
rtyp
A 0 to 1 Setting prohibited
B 2 GZG200W26OHMJ
3 GZG300W20OHMJ
MR-RB32 or GZG200W120OHMJ 3 units connected
4
in parallel
MR-RB30 or GZG200W39OHMJ 3 units connected in
5
parallel
MR-RB50 or GZG300W39OHMJ 3 units connected in
6
parallel
MR-RB31 or GZG200W20OHMJ 3 units connected in
7
parallel
MR-RB51 or GZG300W20OHMJ 3 units connected in
8
parallel
MR-RB65 or GRZG400-2OHMJ 4 units connected in
9
serial
A GZG80W26OHMJ
B GZG400W13OHMJ
C GZG400W8OHMJ
D to F Setting prohibited
E7 F1
F + axis No.
stop
8 - 7
Explanation
9 8 7 6 5 4 3
emgx
Explanation
Details
E7 OFF
Emergency
stop
2 1 0
0