Step 12. Program Cab Display Module (Cdm) - MacDon M150 Assembly Instructions Manual

STEP 12. PROGRAM CAB DISPLAY
MODULE (CDM)
The monitoring system requires programming for
each header and the header must be attached
to the windrower so that the CDM recognizes the
type of header.
Programming the system may be accomplished
with or without the engine running. If the engine is
running, the transmission must be in neutral. If
the engine is not running, the ignition must be on.
Exit programming mode at any time by pressing
the PROGRAM switch or by turning off the
ignition.
The system only needs to be programmed once
for each header.
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Most functions have been pre-
programmed at the factory but can be changed by
the operator if required.
The following functions can be programmed by the
dealer provided he has the applicable information
from the operator and the header is installed:
•
DWA INSTALLED
•
HDR CUT WIDTH
•
HAY CONDITIONER INSTALLED
•
CALIBRATE SENSORS
SIDE DISPLAY
Displays Software Revision Status
Upper Line - D### (CDM)
Lower Line - C### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch
Press To Exit Program Mode.
* Fast scroll applies only when changing KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE
Form 169018
UNLOADING AND ASSEMBLY
The operator may make
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
Proceed as follows to program the CDM:
Header must be attached to the
windrower so that the CDM can detect
the type of header (Header ID), and
adjust
accordingly.
a. Turn ignition key to RUN, or start the engine.
b. Press PROGRAM and SELECT switches together
on CDM to enter programming mode. Header ID
code is displayed.
c. Press SELECT. TRACTOR SETUP? is displayed.
d. Press . SET KNIFE SPEED? is displayed.
e. Press SELECT until DWA INSTALLED? is
displayed.
f. Press or
g. Press SELECT to advance to the next L1 item.
h. Press PROGRAM to exit programming mode.
i. Refer to Detailed Programming Instructions on
following pages.
The functions requiring programming
are highlighted with
Programming Instructions.
If necessary, refer to the M150, M200
Windrower
programming CDM to specific crop
types and conditions.
34
IMPORTANT
the programming mode
.
NOTE
NOTE
Operator's Manual
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line - Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
in the
for
Revision C