0201H - 02Ffh: Hard Disk Error Codes - HP Brio 7100 User Manual

Appendix A The Error Codes
0201h – 02FFh: Hard Disk Error Codes
0201h – 02FFh: Hard Disk Error Codes
Code
0201h Undefined or invalid command.
0202h Address mark not found in sequential
test.
0204h Requested sector not found in sequential
test.
0205h Reset failed.
0207h Drive parameter activity failed.
0208h DMA Overrun error.
0209h A DMA transfer at a 64 KB segment
boundary was rejected by the drive
controller BIOS.
020Ah Bad sector flag detected in sequential
test.
54
Explanation
English
Details/Parts to Check
Hard disk or hard disk controller error.
Check your hard disk drive is installed correctly.
Install new hard disk drive.
If error persists, install new system board.
Hard disk or diagnostic test error.
Re-run the diagnostic tests on your hard disk drive.
If error persists, install new hard disk drive.
Hard disk or diagnostic test error.
Re-run the diagnostic tests on your hard disk drive.
If error persists, install new hard disk drive.
Hard disk controller error.
Check your hard disk drive is installed correctly.
If error persists, install new system board.
Hard disk configuration error.
Check the hard disk drive is correctly configured in
the BIOS setup.
If error persists, install new hard disk drive.
Diagnostic test error.
Re-run the diagnostic tests.
Diagnostic test error.
Re-run the diagnostic tests.
Diagnostic test error.
Re-run the diagnostic tests.