HP Brio 7100 User Manual page 68

Appendix A The Error Codes
0201h – 02FFh: Hard Disk Error Codes
Code
0281h All Sectors in Test Cylinder are bad.
0290h Drive is busy.
0293h Command aborted.
0295h Data mismatch in sequential test.
0296h Sleep error.
02AAh Drive not ready in sequential test.
02CCh Bit 5 (write error bit) of the hard disk
controller status register is set on
completion of a write operation.
02EEh The Performance test was run on a drive
with less than 200 cylinders.
02F1H Error in partition table.
02F3H Boot sector error.
02F4H Media error.
56
Explanation
English
Details/Parts to Check
Hard disk error.
Install new hard disk drive.
Re-run the diagnostic tests.
The command is not supported by the device.
No action needed.
Hard disk error.
Check your hard disk drive is installed correctly.
If error persists, install new hard disk drive.
The command is not supported by the device.
No action needed.
Hard disk error.
Check your hard disk drive is installed correctly.
If error persists, install new hard disk drive.
Hard disk or hard disk controller error.
Check your hard disk drive is installed correctly.
Install new hard disk drive.
If error persists, install new system board.
Hard disk configuration error.
Check the hard disk drive is correctly configured in
the BIOS setup.
If possible, select a drive type with more than 200
cylinders.
Read error in disk partition area.
Format, or re-format, the partition.
Format, or re-format, the partition.
If error persists, install new hard disk drive.
Format, or re-format, the partition.
If error persists, install new hard disk drive.