HP Brio 7100 User Manual page 62

Appendix A The Error Codes
0001h – 00CCh: System Error Codes
Code
00A4h NVRam base address is invalid.
00A5h PnP function 42 failed.
00A6h PnP function 43 failed.
00A7h NVRam test failed.
00C0h Non-Intel processor.
00C1h Non-Pentium processor.
00C2h Non-MMX processor.
00C3h MMX Registers Read/Write failed.
00C4h Wraparound Arithmetic test failed.
00C5h Saturation Arithmetic test failed.
00C6h Pack with signed saturation failed.
00C7h Pack with unsigned saturation failed.
00C8h Unpack high packed data failed.
00C9h Unpack low packed data failed.
00CAh Exit MMX state instruction (EMMS)
failed.
00CBh Matrix transpose test failed.
00CCh MMX performance failed.
00FFh Out of memory.
50
Explanation
English
Details/Parts to Check
Install new system BIOS.
Install new system BIOS.
Install new system BIOS.
Install new system BIOS.
If error persists, install new system board.
Install Intel processor.
Install Pentium processor.
Install MMX processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Install new processor.
Re-run the HP Hardware Diagnostics utility using
keyboard only.