Starting Diagtools From The Hard Disk Drive; If There Is A Problem - HP Kayak XU700 User Manual

Hp kayak pc workstations and hp vectra pcs - diagtools user guide

Hide thumbs Also See for Kayak XU700:

Table of Contents

NOTE

CAUTION

1 Starting DiagTools

Starting DiagTools from the Hard Disk Drive

To run DiagTools from the hard disk drive, your PC must have the

correct boot (start) configuration. All Net Vectra PCs are provided with

a ready-to-use Hardware Diagnostics dual boot configuration.

If you have a Net Vectra PC, you can start the Hardware Diagnostics

from the hard disk drive. To do this:

1 Quit all applications, shut down the operating system, and restart

your PC. To do this in Windows NT 4.0, click the Start button then

select

Shut Down – Restart PC

2 When the PC starts you have the choice between Hardware

Diagnostics or your usual operating system. Select the Hardware

Diagnostics option. The Hardware Diagnostics will start

automatically, displaying the Welcome screen (refer to page 11).

Do not remove the

root of the C:\ drive because DiagTools will not work without these files.

Also, DiagTools will not work if you convert the hard disk drive to NTFS

(Windows NT File System) format.

If you have a Net Vectra PC and cannot start Hardware Diagnostics,

your PC may not be correctly set up to run the diagnostic tool. Contact

your network administrator or, alternatively, contact your local or HP-

dedicated Support Agent.

English

and

CONFIG.SYS

AUTOEXEC.BAT

files from the

Table of Contents

Diagtools