Starting Diagtools From A Diskette; If There Is A Problem - HP Brio 7100 User Manual

NOTE
1 Starting DiagTools

Starting DiagTools from a Diskette

Starting DiagTools from a Diskette
Once you have created the diskette(s), you can start the Hardware
Diagnostics. To do this:
1 Insert the diskette into the floppy disk drive. If there is more than
one diskette, insert the "First" or "Boot" diskette.
2 Quit all applications, shut down the operating system, and restart
your PC. To do this in Windows 9x or Windows NT 4.0, click
click
Shut Down
3 The PC will then start from the diskette. After loading the system
files, it will decompress the necessary files. Then DiagTools will start
automatically, displaying the Welcome screen (refer to page 10).
If your computer does not have a SCSI controller, you will see the
following error message:
Unable to find any AIC-78XX/AIC-75XX
ASPI8DOS.SYS installation failed
This is normal. Wait for the computer to boot and display the DiagTools
Welcome screen.

If There is a Problem

You may experience one of the following problems:
PC does not boot (start) from the diskette.
•
This happens when the PC ignores the diskette and starts from the
hard disk drive as normal, running your operating system. The
problem could be:
a Your PC's Setup program may not be correctly configured.
Ensure that the option to start from the floppy disk is enabled.
(Refer to "More Information About The PC's Setup Program" on
page 7.)
b There may be problem with the floppy disk drive or the internal
cable connections. Contact your local or HP-dedicated Support
Agent.
8 English
, and then click
Restart the computer
.
,
Start
.