HP Brio 7100 User Manual page 89

Code
100Ch Memory map I/O access test failed on
processor X at address XXXXXXXXh.
100Dh Application processors were not
detected.
100Eh CPU speed error.
100Fh CPU count error.
1010h Configuration access mechanism test
failed.
1011h TagRAM control register read failed.
1012h TagRAM control register write failed.
1013h Value read back from TagRAM control
register is not the same as the value
written.
Explanation
1000h – 100Dh: Multiple Processor Error Codes
Details/Parts to Check
Processor error.
Install a new processor.
Processor error.
Check that the processor is correctly configured.
If the error persists, install new processor.
Processor speed error.
Check processor Speed stamp and clocks.
If the error persists, install new processor.
Processor error.
Check number of processors present.
Check processor, L2 cache and main memory are
correctly installed.
If problem persists, install new:
L2 memory (if installed in accessory slot), or
•
processor (if integrated on the processor card).
•
Check processor, L2 cache and main memory are
correctly installed.
If problem persists, install new:
L2 memory (if installed in accessory slot), or
•
processor (if integrated on the processor card).
•
Check processor, L2 cache and main memory are
correctly installed.
If problem persists, install new:
L2 memory (if installed in accessory slot), or
•
processor (if integrated on the processor card).
•
Check processor, L2 cache and main memory are
correctly installed.
If problem persists, install new:
L2 memory (if installed in accessory slot), or
•
processor (if integrated on the processor card).
•
Appendix A The Error Codes
English 77