Table of Contents
Advertisement
5.5
Adjusting the circular
level step-by-step
5.6
☞
48
2.
Turn on the instrument. Connect the instrument to the field control-
ler. Using the tribrach footscrews, level the instrument with the
electronic level.
Electronic level:
☞
Select Devices from the Home Menu.
•
Tap the arrow button to the right of the device name.
•
To display the electronic level, tap Compensator.
•
3.
Check the position of the circular level on the instrument and tri-
brach.
If both circular levels are centred, no adjustments are necessary.
☞
4.
If one or both circular levels are not centred, adjust as follows:
Instrument: If it extends beyond the circle, use the supplied allen
key to centre it with the adjustment screws. Turn the instrument by
200 gon (180°). Repeat the adjustment procedure if the circular
level does not stay centred.
Tribrach: If it extends beyond the circle, use the supplied allen key
to centre it with the adjustment screws.
After the adjustments, all adjusting screws must have the same
☞
tightening tension and no adjusting screw should be loose.
Adjusting the Circular Level of the Prism Pole
1.
Suspend a plumb line.
2.
Use a pole bipod, to align the
prism pole parallel to the plumb
line.
3.
Check the position of the circular
level on the prism pole.
4.
a
If the circular level is
centred, no adjustment is
necessary.
b
If the circular level is not
centred, use an allen key
to centre it with the
adjustment screws.
☞
After the adjustments, all adjusting screws must have the same
tightening tension and no adjusting screw should be loose.
Inspecting the Laser Plummet of the Instrument
The laser plummet is located in the vertical axis of the instrument. Under nor-
mal conditions of use, the laser plummet does not need adjusting. If an
adjustment is necessary due to external influences, return the instrument to
any Leica Geosystems authorised service workshop.
4b
4a
TS_080
Check & Adjust
1
2
Advertisement
Table of Contents
