Table of Contents
Advertisement
4.2
Attaching the Com-
municationHandle
step-by-step
Setup for Remote
Control with Commu-
nicationHandle
32
Remote Control Setup
b
16200_001
Refer to "4.1 Instrument Setup" for the initial instrument setup onto
☞
a tripod.
1.
To remove the instrument carry handle: Press and hold the four
unlock push buttons and lift off the handle.
2.
To install the CommunicationHandle, first make sure that the inter-
face connection on the lower part of the handle is on the same side
as the Communication side cover. Then press and hold the four
unlock push buttons and attach the handle.
Ensure that there is a tight fit with the instrument after releasing
☞
the push buttons. If no connection can be found, re-check that
handle is seated firmly.
3.
Swing the antenna of the CommunicationHandle into an upright
position.
Refer to field software manual for additional information.
☞
a
b
c
d
16540_001
c
e
f
a
Prism pole
b
GHT63 clamp
g
c
CC80 field controller on
h
CMB10 holder
d
360° prism
e
CCD6/RH16/RH17 Communic-
ationHandle
f
Instrument
g
Communication side cover
h
Tripod
Operation
Advertisement
Table of Contents
