Uninstalling the
previous drivers
Install Leica USB
drivers
Operation
Skip the following steps if you have never installed Leica USB drivers
☞
before.
If older drivers were previously installed on the PC, follow the instructions to
uninstall the drivers prior the installation of the new drivers.
1.
Connect your instrument to the PC via cable.
2.
On your PC, select to Control Panel > Device Manager.
3.
In Network Adapters, right-click on Remote NDIS based LGS....
4.
Click on Uninstall.
5.
Set Delete the driver... as checked. Press OK.
1.
Start the PC.
2.
Run the Setup_Leica_USB_XXbit.exe to install the drivers necessary
for Leica devices. Depending on the version (32bit or 64bit) of the
operating system on your PC, you have to select between the three
setup files following:
Setup_Leica_USB_32bit.exe
•
Setup_Leica_USB_64bit.exe
•
Setup_Leica_USB_64bit_itanium.exe
•
☞
To check the version of your operating system, go to
Control Panel > System > System type.
☞
The setup requires administrative privileges.
☞
The setup has to be run only once for all Leica devices.
3.
The Welcome to InstallShield Wizard for Leica GS, TS/TM/MS,
CS and GR USB drivers window appears.
☞
Ensure that all Leica devices are disconnected from your
PC before you continue!
39