Installing The Aileron Servos - Seagull Models SEA 302 Assembly Manual

RENO AIR CARE YAK-11 "PERESTROIKA"
3.
Flap control horn

INSTALLING THE AILERON SERVOS

1.
2.
Minimum servo spec.
Torque : 80 oz-in (5.8 kg-cm) @ 4.8V;
100 oz-in (7.2 kg-cm) @ 6.0V
Because the size of servos difer, you
may need to adjust the size of the precut
opening in the mount. he notch in the
sides of the mount allow the servo lead to
pass through.
6
Instruction Manual.
1) Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
3.
2) Use drill bit in a pin vise to drill the
mouting holes in the blocks.
4.
3) Apply 2-3 drops of thin C/A to each
of the mounting holes. Allow the C/A to
cure without using accelerator.
5.
C/A glue
4) Use dental loss or heatshrink tube to
secure the connection so they cannot be-
come unplugged.
6.
1.5mm