Table of Contents
Advertisement
1.
2) A scale pilot is included with this ARF.
he Pilot included itting well to the cock-
pit. (or you can order others scale pilot
igures made by SG Models. hey are
available at SG Models distributors.)
If you are going to install a pilot igure,
please use a sanding bar to sand the base
of the igure so that it is lat.
3) Position the pilot igure on the canopy
loor as show. Locate the oval shaped on
the canopy loor and remove the cover-
ing. Use epoxy to glue this into the base of
the pilot igure and glue the cockpit panel
in place with C/A glue, please see pictures
as shown.
2.
3.
4.
110mm
4) Epoxy canopy onto the fuselage. Trace
around the canopy and onto the fuselage
using a epoxy.
5.
Epoxy.
INSTALLING THE BATTERY-RECEVER.
1) Plug the servos leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
3) Route the antenna in the antenna tube
inside the fuselage and secure it to the
bottom of fuselage using a plastic tape.
Epoxy.
31
Advertisement
Table of Contents
