Table of Contents
Advertisement
Programmable Features
PROGRAMMING FEATURES
A matrix of all programmable features and their options are on the next page� For detailed infor-
mation on each feature, please refer to the operation manual� Use the procedure below to make
any necessary changes�
Step 1 Turn the ignition key "ON", then "OFF"
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user features (Press
10 times to access installer features)�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times corresponding
with the desired feature's number�
~ The siren/horn will chirp equal to the selected feature�
Step 4
4-button & 2-way MODELS: Change the feature by pressing the transmitter button that cor-
responds with the desired setting�
1-button MODELS: Change the feature by pressing the brake pedal the same number of times
that corresponds with the desired setting� NOTE: some cars require the ignition to be on for
the brake circuit to operate. In this case, turn on the ignition before pressing the brake.
~ The siren/horn will chirp equal to the selected setting�
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time�
Step 6 To exit programming, turn the ignition key "ON" then "OFF"� Or, it will exit automatically
after 10 seconds of no activity�
This device complies with FCC Rules part 15� Operation is subject to the fol-
lowing two conditions, (1) This device may not cause harmful interference and,
(2) This device must accept any interference that may be received, including
interference that may cause undesired operation�
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user's authority to operate the equipment�
14
Advertisement
Table of Contents
