Table of Contents
Advertisement
This port provides a direct digital interface for any Omega IntelliKit, OmegaLink interface mod-
ule, or other accessories� It can eliminate the need for several wire-to-wire connections� Refer to
the wire diagram overview on page 8 to see which circuits are supported by this port and compare
them to the data functions available from the interface module� This port is also capable of com-
municating with the standard D2D (Trilogix) protocol and with the ADS (iDataLink) protocol� This
is selectable with installer feature #13� This port also supports a plug-in accessory independently
from the black data port described below� BOTH THE GREEN AND BLACK PORT CAN BE
USED SIMULTANEOUSLY FOR PLUG-IN ACCESSORIES�
This port provides a direct digital interface for any OmegaLink interface modules� It can elimi-
nate the need for several wire-to-wire connections� Refer to the wire diagram overview on page 8
to see which circuits are supported by this port and compare them to the data functions available
from the interface module� This port is also capable of communicating with the standard D2D
(Trilogix) protocol and with the ADS (iDataLink) protocol� This is selectable with installer feature
#13�
BLADE OPERATIONS: This port is also used to update the firmware for any BLADE cartridge
used in lieu of a standard interface module� When connected to the OmegaLink OL-LOADER,
this port can also be used to configure all programmable features as well as update the entire
system's firmware. These functions may require a BLADE cartridge to be installed.
BLADE CARTRIDGE PORT
On the bottom of the main module, there is a slide door� This door is removed and replaced
with any BLADE cartridge being used� The port is keyed so the cartridge will only insert one way�
Do not use excessive force to install the BLADE, it should snap in with light to moderate pressure�
Also, refer to the install guide for the BLADE firmware being used for further information and
details� When this system detects a BLADE module, the data port protocol will automatic switch to
the ADS protocol� For more info on BLADE modules, visit www�omegaweblink�com�
BLADE HARNESS PORT
When utilizing an OmegaLink BLADE module, this 20 pin connector is used for the harness
that is included with the BLADE module� This allows you to connect directly to the vehicle's data
bus and other required circuits for the interface�
This system is equipped with 2 white dual zone sensor ports� Any Omega single or dual zone
sensor will plug directly into these ports� A dual zone shock sensor is included with this system� If
more than 2 sensors are desired, you can expand a single port with the AU-EXP module� It adds 3
additional sensor ports to the system�
Black Data/Programming Port
BLADE Cartridge Port
Dual Zone Sensor Ports (WHITE)
Green Data Port
11
Advertisement
Table of Contents
