Table of Contents
Advertisement
PINK WIRE - 3RD CHANNEL (-) OUTPUT
This output provides a 250mA negative output when the CH3 function is activated by the con-
troller� The output will remain as long as the controller button(s) is held�
CONNECTION: Connect this wire to any desired add-on accessory that can utilize a negative
activation input�
WHITE/BLUE WIRE - REMOTE START ACTIVATION (-) INPUT
This input will activate the system's remote start function when it receives 2 negative pulses�
Another 2 pulses during remote start operation will turn off the remote start� You can change this
to a single pulse activation with user feature 17�
CONNECTION: Connect this wire to any device that you desire to activate remote start�
WHITE WIRE - ALARM ARM (-) INPUT
This input will arm the system's alarm when it receives a negative pulse�
CONNECTION: Connect this wire to any device that you desire to arm the alarm� It requires a
negative pulse input�
BROWN WIRE - ALARM DISARM (-) INPUT
This input will disarm the system's alarm when it receives a negative pulse�
CONNECTION: Connect this wire to any device that you desire to disarm the alarm� It requires a
negative pulse input�
LT� GREEN/RED WIRE - OEM ALARM ARM / CH4 (-) OUTPUT
This output provides a 250mA negative pulse when remote start is turned off and when the
system's alarm is armed� It can be programmed for 4th channel output with installer feature #9�
CONNECTION: Connect this wire to the vehicle's OEM alarm arm circuit� Typically, it will show
ground when the door cylinder key is turned to the lock position�
LT� GREEN/BLACK WIRE - OEM ALARM DISARM / CH5 (-) OUTPUT
This output provides a 250mA negative pulse when remote start is activated and when the
system's alarm is disarmed� It can be programmed for 5th channel output with installer feature #9�
CONNECTION: Connect this wire to the vehicle's OEM alarm disarm circuit� Typically, it will show
ground when the door cylinder key is turned to the unlock position�
GREEN WIRE - START (-) OUTPUT
This output provides a 250mA negative pulse when the large VIOLET start wire is active�
CONNECTION: If a negative starter circuit is needed, connect this directly to the vehicle's nega-
tive starter circuit� Otherwise, use a relay (or RS-RP module) to convert this to a high current
circuit�
RED WIRE - CONSTANT (+) OUTPUT
This output provides a 500mA positive output to drive the positive pin of added relay coils�
BLUE WIRE - IGNITION (-) OUTPUT
This provides a 250mA negative output when the large PINK ignition wire is active�
CONNECTION: If a negative ignition circuit is needed, connect this directly to the vehicle's nega-
tive starter circuit� Otherwise, use a relay (or RS-RP module) to convert this to a high current
circuit�
6 Pin Secondary Wire Harness
3 Pin Satellite Relay Port (RED)
7
Advertisement
Table of Contents
