Sharp MX-C303W Troubleshooting Manual page 16

Hide thumbs Also See for MX-C303W:

General Problems

THE IMAGE IS SKEWED ON THE PAPER

Check

Is too much paper loaded into the

bypass tray?

Are the tray guides adjusted to the

width of the paper?

Are the original guides adjusted to the

width of the paper?

LINES APPEAR IN THE IMAGE

Check

Are the scanning areas of the

document glass or automatic

document feeder dirty?

Is the bypass feed roller dirty?

Did you clean the main charger of the

photoconductive drum?

Did you clean the laser unit?

Did you execute Black Streak

Reduction of system setting?

Solution

■ Reload the paper. Load no more than the maximum number of sheets and do not

exceed the indicator line.

The maximum number of sheets varies depending on the paper type setting.

■ Adjust the tray guides to the paper size so that they are neither too tight nor too

loose for the width of the paper.

■ Adjust the original guides to the width of the paper.

Solution

■ Clean the scanning areas of the document glass or automatic document feeder.

► Maintenance (page 6)

■ Clean the surface of the bypass feed roller.

► Maintenance (page 6)

■ Clean the main charger of the photoconductive drum. For details on cleaning,

refer to the User's Manual.

■ Clean the laser unit. For details on cleaning, refer to the User's Manual.

■ Execute in "Settings (administrator)" → [System Settings] → [Image Quality

Adjustment] → [Collective Adjustment] → [Black Streak Reduction]. To detect

black streaks, enable [Display warning message for black streaks detection.]. For

more information on the setting, refer to the User's Manual.

Table of Contents