Sharp MX-C303W Troubleshooting Manual page 14

General Problems
Check
Is the paper size specified?
Did you add paper to tray?
Are you using punched paper?
Are you using label sheets that
cannot be used?
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
Have you forgotten to remove the
divider plate even though A4 size
paper is loaded in tray 1?
Does the machine recognize the
paper size even though 8-1/2" x 14"
size is correctly loaded in tray 2 to 5?
Did you load an envelope?
Did you load paper that is already
printed by this printer or multifunction
device?
THE OUTPUT SCATTERS
?
Check
Is the output extension tray
extended?
Solution
!
■ Be sure to specify the paper size.
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ When adding paper, remove any paper remaining in the bypass tray, combine it
with the paper to be added, and reload as a single stack.
If paper is added without removing the remaining paper, a misfeed may occur.
Do not add paper in tray 1 to 5.
■ When using punched paper, set the paper type to punched.
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings] →
[Paper Tray Settings] → [Tray Registration]
■ Labels without a carrier sheet may stick to the transfer surface and cause a
misfeed.
■ This may improve some states of paper curling.
► Placing the original and adding paper (page 5)
■ When loading A4 size paper in tray 1, remove divider plate. Move divider plate all
the way to the paper feed opening (right side), and pull up.
► Placing the original and adding paper (page 5)
■ Configure the paper size setting in Paper Tray Settings.
► I DON'T KNOW HOW TO CHANGE THE PAPER SIZE (page 15)
■ When loading 8-1/2" x 14" size paper in tray 2 to 5, remove divider plate. Move
divider plate all the way to the paper feed opening (right side), and pull up.
■ If the machine does not recognize the paper size even though 8-1/2" x 14" size is
correctly loaded in tray 2 to 5, check if the holder in the tray is positioned at 8-1/2"
x 14".
Divider plate
► Placing the original and adding paper (page 5)
■ Do not load envelopes except the bypass tray.
■ Set the paper type to "Envelope", and for the paper size, specify the paper size you set.
■ Only load paper printed by this printer or multifunction device in the bypass tray.
■ Load only one sheet at a time.
Solution
!
■ The output extension tray is on the output tray.
■ Open the output extension tray and pull out to use.
14
8
1/2
Holder