Sharp MX-C303W Troubleshooting Manual page 15

General Problems
PAPER DOES NOT FEED FROM THE PAPER TRAY
?
Check
Is the paper loaded correctly into the
paper tray?
Has the tray been prohibited in some
modes (copy, print, fax, image send,
document filing)?
I DON'T KNOW HOW TO CHANGE THE PAPER SIZE
?
Check
Set the paper size used in each tray in
the tray settings.
THE OUTPUT IS NOTICEABLY CURLED AND UNEVEN
?
Check
Remove the paper, turn it over, and
reload it. Using a different paper type
may solve the problem.
Solution
!
■ Set the guides to the size of the paper.
Reload the paper. Load no more than the maximum number of sheets and do not
exceed the indicator line. Push the paper tray slowly and firmly all the way into
the machine.
► Placing the original and adding paper (page 5)
■ Check the settings in [Paper Tray Settings] and see if checkmarks appear in the
checkboxes of each mode ([Feeding Approved Job]). Functions without a
checkmark cannot be used for printing using that tray.
 "Settings" → [System Settings] → [Common Settings] → [Paper Settings]
→ [Paper Tray Settings] → [Tray Registration] → [Feeding Approved Job]
Solution
!
■ The "Tray Settings" key can be found in the home screen.
Tap this key to display the tray settings screen.
Tap the tray whose paper size you want to change, select the paper type, and
then tap the [Size] tab. Select the paper size and tap the [OK] key.
If you loaded a special size of paper in the bypass tray, tap the [Direct Entry] key
after tapping the [Size] tab, enter the paper size manually, and tap the [Execute] key.
Solution
!
■ This may improve some states of paper curling.
► Placing the original and adding paper (page 5)
15