Table of Contents
Advertisement
8. The stock 36 grit belts that the machine comes with works best for most notching application,
although other grits are available.
Material Insertion
1. Once the proper mandrel and belt are installed, the material to be notched can be inserted
into the vise.
2. Open the vise an insert the material so that the end toward the mandrel extends past the
vise jaw approximately 2-3" (51-76mm) re-tighten the vise.
Note: Angled notches may require more material extending from the vise.
3. If an angle notch is required, loosen vise assembly by opening the locking lever and rotate
and position the vise assembly to the desired angle and retighten the lock lever, not to
exceed 60 degrees.
17
17
B
Advertisement
Table of Contents
