Table of Contents
Advertisement
MATERIAL SELECTION
CAUTION:
processed through the machine are NOT potentially hazardous to operator or
personnel working nearby.
When selecting materials keep these instructions in mind:
• Material must be clean and dry. (without oil)
• Material should have a smooth surface so it processes easily.
• Dimensional properties of material must be consistent and not exceed the machine capacity
values.
• Chemical structure of material must be consistent.
• Buy certificated steel from the same vendor when possible.
LUBRICATION AND MAINTENANCE
Note: Proper maintenance can increase the life expectancy of your machine.
• Check for any loose or worn parts; contact your dealer for replacement parts.
• Fluid level in aluminum housing should be checked periodically, add 80w gear oil if fluid
levels are low. When completely empty, the aluminum block will hold 1 oz. of oil.
• Replacement seals, bearings, threaded hole saw studs, and drive hexes are all available to
keep your machine running for years.
• Replace the hexed drive stud when it becomes worn.
It must be determined by the customer that materials being
14
14
Advertisement
Table of Contents
