Electrical - Baileigh Industrial TN-600 Operator's Manual

ELECTRICAL

ATTENTION: HAVE ELECTRICAL UTILITIES CONNECTED TO MACHINE BY A
CERTIFIED ELECTRICIAN!
Your Baileigh Machine is
Check if the available power supply is the same as required by the machine (consult
nameplate on machine)
WARNING:
to avoid electric shock. DO NOT switch the position of the green grounding wire if
any electrical plug wires are switched during hookup.
Motor Specifications
Your tool is wired for 220 volt, 50Hz alternating current. Before connecting the tool to the power
source, make sure the machine is cut off from power source.
Considerations
 Observe local electrical codes when connecting the machine.
 The circuit should be protected with a time delay fuse or circuit breaker with a amperage
rating slightly higher than the full load current of machine.
 A separate electrical circuit should be used for your tools. Before connecting the motor to the
power line, make sure the switch is in the "OFF" position and be sure that the electric current
is of the same characteristics as indicated on the tool.
 All line connections should make good contact. Running on low voltage will damage the
motor.
 In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is equipped with an electric cord
having an equipment-grounding conductor and a grounding plug. The plug must be plugged
into a matching outlet that is properly installed and grounded in accordance with all local
codes and ordinances.
WARNING:
properly grounded. If you are not sure, have a qualified electrician check the
receptacle
.
Make sure the grounding wire (green) is properly connected
In all cases, make certain the receptacle in question is
14
14
Certified