Table of Contents
Advertisement
3. FPGA Configuration
To configure the FPGA via JTAG directly, select FPGA icon detected by
Boundary-Scan and assign a bit-stream file.
If configuration is completed successfully, the DONE LED will light up.
4. Configuration Device Programming
To download a an FPGA configuration data to the configuration device via JTAG, a
mcs file is required. To generate an mcs file using iMPACT, please refer to the
following steps.
4.1. Generating mcs file
Start iMPACT, and double-click [Create PROM File] and set items as shown
below.
Storage Target
Storage Device
File Format
Others
Select your bit file, and generate MCS file.
4.2. Programming Configuration Device
Assign the mcs file to Flash icon and choose [SPI PROM – M25P16] for device
type, then right click and select a command.
Please set FPGA configuration mode to [Master Serial/SPI] mode.
XCM-306 Series v1.0
: SPI Flash – Configure Single FPGA
: 16M (one device)
: MCS
: any
6
Advertisement
Table of Contents
