Table of Contents
Advertisement
4. FPGA Configuration
To configure the FPGA via JTAG, please refer to the following steps.
1. Double-click [Configuration Target Device] in [Processes] tab.
2. Select [Configure devices using Boundary-Scan (JTAG)].
3. Open the bit file you made.
4. Confirm [Verify] is not checked in [Device Programming Properties] dialog.
5. Select the FPGA icon, then open [Operations] menu and click [Program].
If configuration is completed successfully, the DONE LED will light up.
5. Configuration Device Programming
To program the configuration device via JTAG , you need to prepare mcs file. You
can generate mcs file using ISE. Please refer to the following steps.
Generating mcs file
1. Double-click [PROM File Formatter] in [Configuration Modes] tab.
2. Select [Xilinx PROM] for target and choose [MCS] for PROM File Format.
3. Enter [PROM File Name].
4. Check [I am using a Xilinx PROM in Serial Mode].
5. Select and add the device which on the board from [Select a PROM] list.
(For 1500 and 2000, add two PROMs)
6. Open the [bit file] in [Add device] dialog.
(For 1500 and 2000, apply %filename%_0.mcs to the left PROM icon, %filename%_1.mcs to the right PROM icon.)
7. Open [Operations] and click [Generate File].
Programming Configuration Device
8. Click [Boundary Scan] in [Configuration Mode] window.
9. Select the configuration device icon, then open [Operations] and click [Program].
10. Check [Verify] and [Erase Before Programming], then click [OK].
Then it will show you the message "Program Succeeded".
XCM-005 Series v1.0
6
Advertisement
Table of Contents
