Fpga Configuration; Configuration Device Programming; Generating Mcs File; Programming Configuration Device - Humandata XCM-018Z User Manual

4. FPGA Configuration

To configure the FPGA via JTAG directly, select FPGA icon detected by
Boundary-Scan and assign a bit-stream file.
If configuration is completed successfully, the DONE LED will light up.

5. Configuration Device Programming

To download a FPGA configuration data to the configuration device via JTAG, mcs
file is required. To generate an mcs file using iMPACT, please refer to the following
steps.

5.1. Generating mcs file

Start iMPACT, and double-click [Create PROM File] and set items as shown
below.
Storage Target
Storage Device
File Format
Others
Select your bit file, and generate MCS file.

5.2. Programming Configuration Device

Assign the mcs file to Flash icon and choose [SPI PROM – M25P32] or [SPI
PROM – M25P64] for device type, then right click and select a command.
Please set FPGA configuration mode to [Master Serial/SPI] mode.
XCM-018Z Series v1.0
: SPI Flash – Single FPGA
: 32M or 64M (set one device)
: MCS
: any
8