Ghost Controls DTP1XP Installation And Owner's Manual page 25

PREPARING THE GATE SYSTEM CONTROLLER
The gate system control board provides one convenient place to make all of your system connections and to change any
settings that you desire to personalize how your automatic gate opener system operates at your home or property. This main
board (shown below) is located inside of the control box of your system and will be referred to in detail through the next few
sections. Because this control box may be mounted within reach of children or potential vandals, we recommend adding a
padlock to safely lock this box in the closed position to prevent tampering. NOTE: BEFORE PROCEEDING MAKE
SURE THE ON/OFF SWITCH ON BOTTOM OF CONTROL BOX IS IN THE OFF POSITION
STEP 10. Check the system DIP switch settings and verify that they are in the correct positions
as shown.
DIP Switch # OFF Position
1
2
3
4
Factory Default:
Pull-To-Open
Warning Disabled
Factory Default:
SafeForce Mode
®
Factory Default:
Delay Open 2nd Arm
ON Position
Push-To-Open
Factory Default: Warning Enabled
Monitored External Safety Devices Mode
Simultaneous Open
© G h o s t C o n t r o l s
®
25
2 0 2 0