Intellitronix DP2002W Installation Manual page 8

Recording and Viewing Performance Data
Follow these steps to record and recall Performance Data (high speed, ¼mile ET, and 0-60 time):
1. Before each run, your car must be at a complete stop at the starting position. Press and hold
the push-button as it cycles through the performance data. At the end, the odometer will reset
and all performance data will be cleared. This will not affect your stored calibration value or
the odometer reading.
2. Press the push-button until 'HI-SP' is displayed. The gauge will automatically cycle through
the performance data.
3. Start the run, pass, session, etc., as mentioned above.
4. When finished, repeat Step 2 to view the data gathered from the run. While stopped, you can
view this data as often as you wish. However, once it finishes scrolling one time, the memory
is ready to record new data and will begin recording again once the vehicle starts to move.
The highest speed measured over multiple runs will be retained in memory.
8 – DP2002 Intellitronix
# # #
(rev.11/29/2019)
www.intellitronix.com