Renesas IE850A User Manual page 10

E2, IE850A
2.3.1 Example of recommended connections for both debugging (4-pin LPD) and programming (2-
wire UART or CSI)
Refer to section 2.3.4, Connecting the RESET pin, for more information on the reset circuit.
•
For details on TVDD, refer to section 2.3.5, Connecting the TVDD pin.
•
Make wiring runs between the 14-pin connector and target device as short as possible (within 50 mm is
•
recommended). Do not connect the signal lines between the connector and MCU to other signal lines.
Use GND to apply a guard ring for the wiring which runs between the 14-pin connector and target device.
•
Do not route high-speed signal lines parallel to each other or allow them to cross each other.
Pin names may vary among target devices. Refer to the user's manual for the target device you are using
•
for the actual pin names.
Proceed with appropriate processing for pins of target devices which do not require connection to the
•
emulator in accord with the descriptions in "Handling of Unused Pins" in the user's manual for the target
device.
During programming (when the RFP is in use), the emulator outputs the high level on FPMD0 and the low
•
level on FPMD1 to cause the device to enter serial programming mode. Connect MD1 and FPMD1 as
required.
During debugging, the emulator does not output signals to FPMD0 or FPMD1 (they are in the high-
•
impedance state).
Connection of emulators from other manufacturers:
The E2 emulator does not support debugging through a JTAG interface; however, if an emulator
from another manufacturer, which supports the JTAG interface, is to be connected, connect the
TMS signal to pin 9 of the 14-pin connector. If you use such an emulator for debugging, be sure to
read its manual beforehand.
R20UT4140EJ0300 Rev.3.00
Oct.09.20
Figure 2-3 Example of Connection
CAUTION
2. Connecting the Emulator and User System
Page 10 of 41