6- Vertical Stabilizer
Pull the rudder out of the vertical fin.
Trial fit the vertical fin in position. Using
a 90 degree triangle, ensure that the
vertical stabilizer is perpendicular to the
horizontal stabilizer .
Using a pencil, trace around the vertical
stabilizer where it meets the fuselage.
Remove the vertical stabilizer from the
fuselage.
Insert the vertical fin into the fuselage, precisely align
the vertical stabilizer as described in step 6C.
Apply the thin CA glue on the vertical stabilizer where it
contacts the fuselage.
! Securely glue together . If coming off during fly,
you lose control of your air plane.
6A
Using s sharp hobby knife, carefully cut away the
covering below the lines which were drawn in the
previous steep. Do not cut into the woods as this
will affect the structural integrity of the stabilizer .
6E
Carefully, push the vertical fin into the
slot on the fuselage as shown .
6C
CA
6B
6D
Cut away only
the covering
7