How To Display/Remove Target Data; How To Select A Tt Symbol (B/W-Types Only); Tt Pop Up Information - Furuno FAR-2228-BB Operator's Manual

3. TARGET TRACKING (TT)
3.9.3

How to select a TT symbol (B/W-types only)

In addition to the "standard" circle TT symbol, you may select from the symbols shown
below, using the full keyboard. This cannot be done with trackball-type control unit
(RCU-015, RCU-016). However, you can program a function key to do so: assign the
function key the [TARGET DATA] function from the [STD KEY] category. For function
key setup, see section 1.9.
To change the TT symbol, do the following procedure.
1. Place the cursor on the target whose symbol you want to change, then left-click.
2. Press the TARGET DATA key to cycle through the symbols and select the de-
sired symbol.
3.10

How to Display/Remove Target Data

The TT mode provides the full functionality of TT as required by the IMO Resolution
A.823(19) and IEC 62288, including display of range, bearing, course, speed, CPA
and TCPA of all tracked targets.
The target bearing is shown in relative bearing in the HEAD UP mode and true bearing
in the COURSE UP, NORTH UP and True Motion modes, with the suffix "R" (Relative)
or "T" (True).
The target speed and course are shown as speed over the ground or speed through
the water depending on speed source.
3.10.1

TT pop up information

The TT pop-up shows abbreviated TT data (target no., COG, SOG, CPA and TCPA)
for the selected TT. Simply put the cursor on the TT symbol to show the pop-up.
The popup can be enabled or disabled with the following procedure.
1. Open the menu.
2. Select [5 TT•AIS].
3. Select [4 TT•AIS SYMBOL].
4. Select [7 TT POP-UP INFO].
5. Select [ON] or [OFF] as required.
6. Close the menu
3-10
TT No.
Abbreviated
TT data