Connecting The Power And Switching On - Gestetner F104 Settings Manual

StellaF2_EN_Combine_F_FM.book Page 200 Friday, February 14, 2003 5:16 PM
Appendix

Connecting the Power and Switching On

R WARNING:
• Connect the power cord directly into a wall outlet and never use an
extension cord.
• Disconnect the power plug (by pulling the plug, not the cable) if the
power cable or plug becomes frayed or otherwise damaged.
• Turn off the power and disconnect the power plug (by pulling the
plug, not the cable) if any of the following occurs:
• You spill something into the machine.
• You suspect that your machine needs service or repair.
• The external housing of your machine has been damaged.
R CAUTION:
• When you disconnect the power plug from the wall outlet, always pull the
plug (not the cable).
A A A A
Plug in the cable to the outlet.
B B B B
Turn the power on.
10
Important
❒ The supply from the wall outlet must not fluctuate more than 12V above
or below 120V.
❒ The power cord should not be laid in a place where it might trip somebody.
❒ Do not lay anything on the power cord.
❒ If you must use an extension cord, make sure that it is capable of carrying
120V/8A, and that your facsimile terminal is the only piece of equipment
connected to that cord.
200