Set The Beeper; Set The Pressure Units And Ibp Sensitivity - Fluke Biomedical ProSim 8 User Manual

ProSim 8
Users Manual

Set the Beeper

You can turn on and off the beeper and set its volume. From the Setup screen,
push  or  to highlight Sound Settings and push . To go back to the
Setup screen, push the Back softkey.
5. Push .
6. Push .
7. Push  or  to highlight On or Off.
When the beeper is set to on, two more variables appear in the Sound Settings
screen.
To set the beeper type:
1. Push  or  to highlight the Beep Type value.
2. Push .
3. Push  or  to highlight the Beeper Type value.
4. Push  to go back to the Sound Settings screen.
To set the beeper volume:
1. Push  or  to highlight the Volume value.
2. Push .
3. Push  or  to highlight the Volume value.
4. Push  to set the volume and go back to the Sound Settings screen.

Set the Pressure Units and IBP Sensitivity

The units of measure for pressure (IBP and NIBP) values and IBP sensitivity to
simulate are set through the pressure Settings. From the Setup screen, push 
or  to highlight IBP Settings in the setup list and push . To go back to the
Setup screen, push the Back softkey.
To set the IBP sensitivity:
1. Push  or  to highlight the IBP Sensitivity value.
2. Push .
3. Push  or  to highlight a Sensitivity value.
4. Push  to set the sensitivity and go back to the Pressure Settings screen.
To set the Pressure units:
1. Push  or  to highlight the Units value.
2. Push .
3. Push  or  to highlight mmHg or kPa.
4. Push  to set the units and go back to the IBP Settings screen.
78
You can set the beeper to beep at each key press or to beep only when an
error occurs.