Installing Modules; Sam1/Sam2/Sim; Microsd Memory Card - Ingenico IWL2G User Manual

4.3.

Installing Modules

4.3.1.

SAM1/SAM2/SIM

CAUTION :
Switch off the terminal before opening the trapdoor.
The SAM/SIM connectors are located inside the terminal,
in a closed compartment.
•
Turn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
•
SAM1, SAM2 and SIM are identified by the engraved marks on
the lower housing
•
When introducing a SAM/SIM in its slot, be sure to put the
cut corner as indicated on the picture
•
Close the trapdoor.
TIP
Use a piece of adhesive tape to grip the SAM for easier and faster removal.
4.3.2.

MicroSD Memory Card

CAUTION :
Switch off the terminal before opening the trapdoor.
MicroSD connector is located inside the terminal, in a closed
compartment.
To install a MicroSD Memory Card :
•
Turn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
•
Remove battery pack (disconnecting is not necessary).
•
Insert the MicroSD Memory Card into the connector slot as
shown on the figure.
Be sure to put the MicroSD contacts downside and the cut
corner as indicated on the figure.
•
Close the trapdoor
The terminal supports MicroSD up to 32GB
•
iWL2xx Wireless Series
900003061 R11 000 04/1050
11/31
Copyright © 2011 Ingenico
All rights reserved
SIM
Cut corner
position
SAM1 SAM2
MicroSD card
Cut corner
position