4.3.
Installing Modules
4.3.1.
SAM1/SAM2/SIM
CAU TION :
Switch off the terminal before opening the trapdoor.
The SAM/SIM connectors are located inside the terminal,
in a closed compartment.
•
Tu rn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
•
SAM1, SAM2 and SIM are identified by the engraved marks on
the lower housing
•
When introducing a SAM/SIM in its slot, be sure to put the
cut corner as indicated on the picture
•
Close the trapdoor.
TIP
Use a piece of adhesive tape to g rip the SAM for easier and faster removal.
4.3.2.
MicroSD M emory Card
CAU TION :
Switch off the terminal before opening the trapdoor.
MicroSD connector is located inside the terminal, in a closed
compartment.
To install a MicroSD M emory Card :
•
Tu rn the terminal and unclip the trapdoor by pushing on the
clips with your nails as shown with the arrows on the picture
•
Remove battery pack (disconnecting is not necessary).
•
Insert the MicroSD Memory Card into the connector slot as
shown on the figure.
Be sure to put the MicroSD contacts downside and the cut
corner as indicated on the figure.
•
Close the trapdoor
The terminal supports MicroSD up to 3 2GB
•
iWL2xx Wireless Series
11/32
900003061 R11 000 05/1122
SIM
Cut corner
position
SAM1
SAM2
MicroSD card
Cut corner
position
Copyright © 2011 Ingenico
All rights reserved
To remove a MicroSD Memory Card :
•
Tu rn the terminal and unclip the trapdoor by pushing on the clips
with your nails as shown with the arrows on the picture
•
Remove battery pack (disconnecting is not necessary).
•
Remove the MicroSD Memory Card. M icroSD connector has
push/pull ability . Push on MicroSD card edge to remove it.
•
Close the trapdoor
•
iWL2xx Wireless Series
12/32
900003061 R11 000 05/1122
Copyright © 2011 Ingenico
All rights reserved