Lubrication And Maintenance - Baileigh Industrial B8105 Operator's Manual

LUBRICATION AND MAINTENANCE

WARNING:
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
• Check daily for any unsafe conditions and fix immediately.
• Check that all nuts and bolts are properly tightened.
• On a weekly basis clean the machine and the area around it.
• Lubricate threaded components and sliding devices.
• Apply rust inhibitive lubricant to all non-painted surfaces.
Note: Proper maintenance can increase the life expectancy of your machine.
• The fluid level in the power unit's reservoir should be checked monthly. If the level is below
1/2 full, fill to the top with AW-46 hydraulic fluid. Hydraulic fluid and the filter should be
changed when the filter gauge reads "Change Filter".
• Check periodically for leaks. If a leak is detected, consult Baileigh Industrial.
• There are four grease zerks on the machine, at the main spindle pivots. Grease these zerks
every month with only two pumps from a standard grease gun.
• Check for any loose or worn parts
• If hoses or fittings are replaced, they must be rated for 4000psi (275 bars, 282 kg/cm).
Make sure the electrical disconnect is OFF before working on
30
30