Machine Adjustments; Lubrication And Maintenance - Baileigh Industrial TN-300 Operator's Manual

MACHINE ADJUSTMENTS

Two of the rollers have an eccentric tension adjuster, they
are the ones that have a hexed shaped portion beneath
the "V" roller.
1. To adjust, loosen the center bolt using a 1/2" wrench,
and then with another wrench to hold the hex, rotate
the hex slightly and the roller will either tighten or
loosen as the hex eccentric is turned.
2. Give it a little tension and tighten the center screw, try
the feed handwheel and check the resistance. The
rollers should NOT be able to rotate by hand, that
would be too loose.

LUBRICATION AND MAINTENANCE

WARNING:
the machine.
Maintenance should be performed on a regular basis by qualified personnel.
Always follow proper safety precautions when working on or around any machinery.
• Check daily for any unsafe conditions and fix immediately.
• Check that all nuts and bolts are properly tightened.
• On a weekly basis clean the machine and the area around it.
• Lubricate threaded components and sliding devices.
• Apply rust inhibitive lubricant to all non-painted surfaces.
Note: Proper maintenance can increase the life expectancy of your machine.
Make sure the electrical disconnect is OFF before working on
16
16