Adtec RD-70 User Manual page 21

3G Mapping SDI 3G Level controls the
Level SDI mapping of the 3G-SDI signal
when decoding 1080P50,
1080P59.94 and 1080P60
streams. The 3G-SDI signal can
be mapped to Level A or Level B
Dual Link. The mapping is
individually configurable for each
set of outputs (SDI and SDIALT).
If 3G-SDI output does not
appear on the downstream
device, the device may not
support the currently configured
mapping mode. Use SDI3GLEVEL
to change the mapping mode.
3G Mapping SDI 3G Level controls the
Level SDIALT mapping of the 3G-SDI signal
when decoding 1080P50,
1080P59.94 and 1080P60
streams. The 3G-SDI signal can
be mapped to Level A or Level B
Dual Link. The mapping is
individually configurable for each
set of outputs (SDI and SDIALT).
If 3G-SDI output does not
appear on the downstream
device, the device may not
support the currently configured
mapping mode. Use SDI3GLEVEL
to change the mapping mode.
Downscaling The Downscaling SDI setting
SDI determines whether the SDI
bank ( SDI Output 1 and 2 ) will
be output natively or downscaled
to SD.
Downscaling The Downscaling SDI setting
SDIALT determines whether the SDI
bank ( SDI Output 3 and 4 ) will
be output natively or downscaled
to SD.
Genlock Menu
Genlock Mode Configures the genlock operation
of the decoder. SLAVE is
primarily used for 3D
applications and REMOTE is used
in standard genlock operation.
A
B
A
B
OFF
SD
OFF
SD
OFF - Disables genlock
SLAVE - Enable Genlock, Decode
source is synchronous to SYNC IN
signal
REMOTE - Enable genlock, Decode
source is NOT synchronous to SYNC