Adtec RD-70 User Manual page 28

IP Tx Menu
Note: this is a parallel menu. It has four indices. Use the left or right arrows to navigate to
desired index.
Item
IP Tx 1 - 4
Mode
Tx IP Address
Tx Port
Tx GW Address
DVB per IP
RTP
FEC Mode
FEC L
Function
Enables IP Egress.
The IP Address of which the Multicast or
Unicast is broadcast. Multicast addressing
supports the transmission of a single IP
datagram to multiple receivers. Valid
Multicast addressing range is
224.10.XXX.XXX to 239.XXX.XXX.XXX.
Unicast addressing sends a single IP
datagram to only one receiver. The
Unicast address will be the unique IP of
the receiving device.
port assignment used for transmitting a
multicast
The Unicast Gateway automatically
handles IP routing for unicast
transmissions. This must be configured if
the outgoing unicast requires a different
gateway from the configured system
default gateway. A route is automatically
added when the unit is configured for
transmit and a Unicast Gateway exists.
The route is deleted if set to 0.0.0.0 or
Multicast Mode set to OFF.
Configures the amount of DVB transport
stream packets ( 188 bytes per DVB
packet ) per IP packet payload
allows for sequence numbering and
timing
Forward Edge Correction; selects on/off.
When selected, sends two FEC RTP
streams in addition to a source RTP
stream enabling a receiver to reconstruct
missing packets in the source stream.
affects the maximum burst packet loss
Options
OFF
SEND
user-defined; numeric
field in format
xxx.xxx.xxx.xxx
user-defined using the
numeric keypad
user-defined; numeric
field in format
xxx.xxx.xxx.xxx
1
4
7
OFF (UDP)
ON (RTP)
OFF
ON
MAXBURST
BURST
LOWLATENCY
4-20