Adtec RD-70 User Manual page 51

Input to Output Routing and Filtering
The SVC-FILTR key must be enabled to configure Service Filtering. When filtering is
enabled, a maximum of 5 programs are allowed on any given output. If filtering is disabled,
all programs available on the input are available on the output, ie, unit is in service pass
through mode.
Configure Service Filter on ASI
To configure service filtering on the ASI output, visit the TS Output -> ASI Tx tab. First
choose your ASI Output Source. The ASI Output can be sourced from ASI IN, RF1 IN, RF2
IN or IP IN, depending on demodulator hardware options. Single tuner demodulators will
have an RF option instead of RF1 and RF2.
Then, choose the ASI Output rate behavior or ASI Output TMR. ASI Output TMR determines
the ASI egress rate. When set to AUTO, the default, the output rate will be the sum of all
filter PIDs configured for the output + minimal NULL stuffing. When set to NATIVE, the
output TMR is set to match the INPUT source TMR. MANUAL is a user defined rate.
Then, choose the service required to filter from the Available Service list. Clicking the right
arrow will add the service to the Assigned Service list.
When the ASI Filter is set to ENABLED and Apply is clicked, you shall now see the selected
service on the ASI Output.