Table of Contents
Advertisement
Troubleshooting
Standard USB port disabled [56]
From the printer control panel, select Continue to clear the message. For non‑touch‑screen printer models,
press
to confirm.
Notes:
•
The printer discards any data received through the USB port.
•
Make sure the USB Buffer menu is not set to Disabled.
Supply needed to complete job
Do either of the following:
•
Install the missing supply to complete the job.
•
Cancel the current job.
The device is operating in Safe Mode. Some print options may be disabled
or provide unexpected results.
Select Continue to clear the message. For non‑touch‑screen printer models, press
Too many flash options installed [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
Too many trays attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
245
to confirm.
Advertisement
Table of Contents
