Kyocera ECOSYS M3645dn Operation Manual page 75

Installing and Setting up the Machine > Energy Saver function
Sleep
To enter Sleep, select the [Energy Saver] key. Message display and all indicators on the operation panel will go out to
save a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Select any key on the operation panel.
The machine will be ready to operate within 15 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 1 minute.
To change the preset sleep time, refer to the following:
Sleep Timer (page 8-31)
Follow the steps below to set the sleep timer for the machine to go into sleep mode when not in use.
1
2
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to the following:
Sleep Rules (models for Europe) (page 8-31)
Display the screen.
[System Menu/Counter] key > [▲] [] key > [Common Settings] > [OK] key > [▲] [] key >
[Timer Setting] > [OK] key > [▲] [] key > [Sleep Timer] > [OK] key
Set the Sleep time.
1
Enter the Sleep time.
NOTE
Use the numeric keys or select the [▲] or [▼] key to enter a number.
2
Select the [OK] key.
Energy Saver indicator
2-26