Kyocera ECOSYS M3645dn Operation Manual page 361

Troubleshooting > Troubleshooting
Symptom
The altitude is 1000 m or
higher and dots appear in
the image.
Paper often jams.
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Printouts are curled.
Cannot print.
Cannot print with USB
memory.
USB memory not
recognized.
Checkpoints
―
Is the paper loaded correctly?
Is the paper of the supported type? Is it
in good condition?
Is the paper curled, folded or wrinkled?
Are there any loose scraps or jammed
paper in the machine?
―
Is the paper loaded correctly?
Is the paper damp?
Is the paper damp?
Is the machine plugged in?
Is the machine powered on?
Are the USB cable and network cable
connected?
Is the print job paused?
Is the USB host blocked?
―
Corrective Actions
Select the [System Menu/Counter] key
> [Adjust/Maint.] > [Service Setting] >
[Altitude Adj.], and set to an elevation
one level higher than the current setting.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Load the paper correctly.
Load the paper correctly.
Replace the paper with new paper.
Replace the paper with new paper.
Plug the power cord into an AC outlet.
Turn on the power switch.
Connect the correct USB cable and
network cable securely.
Resume printing.
Select [Unblock] in the USB host
settings.
Check that the USB memory is securely
plugged into the machine.
10-13
Reference
Page
―
page 3-2
page 3-4
page 3-4
page 10-27
page 3-2
page 3-2
page 3-2
page 3-2
―
page 2-10
page 2-8
page 7-13
page 8-20
―