Table of Contents
Advertisement
5.4.2 Acquisition Mode
The available acquisition modes are shown in Table 5.7.
The ContinuousRecording and ContinousReadout modes can be used if more than
one camera is connected to the same network and need to shoot images si-
multaneously. If all cameras are set to Continuous mode, then all will send the
packets at same time resulting in network congestion. A better way would be to
set the cameras in ContinuousRecording mode and save the images in the memory
of the IPEngine. The images can then be claimed with ContinousReadout from one
camera at a time avoid network collisions and congestion.
AcquisitionMode
Continuous
SingleFrame
MultiFrame
SingleFrameRecording
SingleFrameReadout
ContinuousRecording
ContinousReadout
Table 5.7: AcquisitionMode and Trigger
.
MAN052 12/2018 V3.2
After the command AcquisitionStart is executed:
Camera aquires image frames continuously. Acquisition can be
stopped by executing AcquisitionStop command.
Camera acquires one frame and acquisition stops.
Camera acquires n=AcquisitionFrameCount frames and acquisition
stops.
Camera saves one image on the on-board memory of the IP engine.
One image is acquired from the IP engine's on-board memory. The
image must have been saved in the SingleFrameRecording mode.
Camera continuosly saves images on the on-board memory of the
IP engine until the memory is full. The size of available on-board
memory is 24 MB.
All Images that have been previously saved by the
ContinuousRecording mode are acquired from the IP engine's
on-board memory.
5.4 Trigger and Strobe
61 of 131
Advertisement
Table of Contents
