Photon Focus MV1-D2048-3D03 Series User Manual page 131

Revision Date
2.5 June 2014
2.6 September 2014
3.0 August 2015
3.1 February 2016
3.2 December 2018
MAN052 12/2018 V3.2
Changes
MV1-D2048-3D04 camera models added.
New model variants H2 (HTL encoder interface) and S10
(Scheimpflug 10°) added.
Chapter Introduction added.
Section High Speed Mode added.
Status field M_TRIG_LEVEL[3:0] added.
Section Power and Ground Connection for GigE H2 Cameras
added.
Revision information now shown in tabular form
Drawing for S10 models (Scheimpflug 10°) added.
Section about setting the camera back focus added.
S10 models for 3D04 removed: they are not available
Trigger timing values corrected
Moving ROI added
Frame rates for latest camera version (V3.1) added.
Dual reset counters added
CE compliance section updated
Section PeakMirror: removed the note that PeakMirror is the
same as rotating camera by 180°: this is not the correct.
Camera version 3.2 added where a bug in moving ROI has
been fixed. Peak filter is now placed before moving ROI and
therefore the filtered peak coordinates are applied to the
moving ROI.
Highspeed mode is not available in combination with moving
ROI. Added notes in High speed mode and moving ROI
chapter.
Camera version 3.3 added, where a bug in HighSpeed mode
has been fixed.
Updated power supply connector description.
Chapter "Warranty" modified.
Chapter "Standards Compliance" added
Chapter "Support and Repair" added
131 of 131