Timeout Between Decodes (Same Barcode) - Newland HR11+ Aringa User Manual

** Enter Setup

Timeout between Decodes (Same Barcode)

Timeout between Decodes (Same Barcode) can avoid undesired rereading of same barcode in a given
period of time.
To enable/disable the Timeout between Decodes (Same Barcode), scan the appropriate barcode below.
Enable Timeout between Decodes (Same Barcode): Do not allow the scanner to re-read same
barcode before the timeout between decodes (same barcode) expires.
Disable Timeout between Decodes (Same Barcode): Allow the scanner to re-read same barcode,
ignoring the timeout between decodes (same barcode).
** Disable Timeout between Decodes (Same Barcode)
The following parameter sets the timeout between decodes for same barcode. It is programmable in
100ms increments from 0ms to 12,000ms. When it is set to 12700, the timeout is infinite. The default
setting is 400ms.
Example: Set the timeout between decodes (same barcode) to 1,000ms
1. Scan the Enter Setup barcode.
2. Scan the Timeout between Decodes (Same Barcode) barcode.
3. Scan the numeric barcodes "1", "0", "0" and "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Exit Setup barcode.
Exit Setup
Timeout between Decodes (Same Barcode)
Enable Timeout between Decodes (Same Barcode)
24